黄色网络天天黄色插电影,三级黄在线高清,落后的欧洲和先进的亚洲,国内美女白浆视频久久网

白城二氧化碳儲罐
  • 白城二氧化碳儲罐
  • 白城二氧化碳儲罐
  • 白城二氧化碳儲罐

產品描述

品牌中杰特裝 型號CFL-20/2.16 類型低溫儲罐 材質16MnDR 適用物料LCO2
液體的排放 liquid discharge
【產品詳情圖片】
2.4.1液體二氧化碳的正常排放是在儲罐增壓后,開啟V2排液閥,V3回氣閥,液體二氧化碳便流入汽化器汽化,供使用點使用。
The normal discharge of liquid carbon dioxide is after pressurization of the tank, open the V2 drain valve, V3 return valve, the liquid carbon dioxide will flow into the vaporizer vaporization for use point.
2.4.2為滿足排液過程的穩定壓力,應按“儲罐的增壓”操作方法進行增壓。
In order to meet the steady pressure of the drainage process, it should be pressurized according to the method of "pressurized tank".
【產品詳情圖片】
【標題】
白城二氧化碳儲罐
二氧化碳儲罐材料
絕熱性能
絕熱材料選用熱態下的珠光砂充填?yuàn)A層并抽真空,夾層封結后真空度標準為:
有效容積:小于等于 10m 3 真空度≤ 2Pa ,大于 10m 3 小于等于 50m 3真空度≤ 3Pa ,大于 50m 3 小于等于 100m 3 真空度≤ 5Pa ,以精湛的技術,獨特的填充工藝,質量保證承諾,以達到的絕熱效果。
安全技術特性
低溫液體二氧化碳儲罐采用 “組合、安全系統閥”使用兩組安全閥同時工作,在安全閥定期校驗時可關閉一側,另一側繼續工作,確保儲罐的安全運行。
操作系統
儲罐內容器上部設置了壓力表,差壓式液位計和液位對照表,可以隨時掌握內容器儲存量及壓力變化,便于充裝及排液時的操作。
檢測系統
儲罐下部設置了儲罐真空檢測、真空規管及真空閥可定期或隨時用真空計進行檢測夾層真空度,確保儲罐的安全運行。
白城二氧化碳儲罐
充液的操作 filling operation
【標題】
充液分為充液和補充充液。
充液的操作如下:
Filling fluid is divided into the first filling and filling fluid.
The first filling operation is as follows:
2.1.1 儲罐吹除置換干凈達到要求后,將充液管線與儲罐的充液接頭連接,液位計組合閥處于平衡狀態準備充液。
After the tank blows off to replace the cleanliness meets the requirements, the filling liquid line is connected with the liquid filling joint of the tank, and the liquid level gauge combination valve is in an equilibrium state to be filled.
2.1.2充入與液體二氧化碳純度相同的氣體,使罐內壓力達到0.8 Mpa以上,方可進行充液。 filled with the same purity of liquid carbon dioxide gas, the tank pressure reached 0.8 Mpa above, before filling.
2.1.3 將充液管線接通槽車,先開啟V5殘液閥,排出管線內的雜質氣體后,再開啟V1進液閥和V7排氣閥,V8液位計組合閥處于全開狀態,顯示液位計讀數進行充液。
The filling liquid line connected tanker, first open the V5 raffinate valve, exhaust gas impurities within the pipeline, and then open the V1 inlet valve and V7 exhaust valve, V8 level gauge combination valve is fully open state, Display level meter readings are filled.
2.1.4 在充液過程中,當液位計指示液位接近標定值時,可間斷開啟V4充滿指示閥,如有液體噴出,應立即停止充液,關閉V4充滿指示閥。
During the filling process, when the liquid level gauge indicates the liquid level approaches the calibration value, the V4 may be intermittently opened to indicate the valve. If any liquid is ejected, liquid filling should be stopped immediately and the V4 valve should be closed.
2.1.5關閉V1進液閥和V7排氣閥,打開V5殘液閥,拆下充液管線,充液結束。
補充充液的操作與充液的操作方法相似,不同點是補充充液時一開始就可以大量充液。
Close the V1 inlet valve and the V7 exhaust valve, open the V5 residual valve, remove the filling line, and fill with liquid.
The procedure for replenishing the priming solution is the same as for the first priming procedure, except that the priming solution can be replenished extensively from the beginning.
【產品詳情圖片】
【標題】
白城二氧化碳儲罐
儲罐的增壓 Tank pressurization
【產品詳情圖片】
當儲罐向外供液又需要穩定排液壓力時,可利用汽化器(另外配備)進行增壓。其操作過程如下:
The carburetor (available separately) can be used for boosting when the reservoir is supplied externally and requires stable discharge pressure. The operation is as follows:
2.3.1開啟V2排液閥,使液體二氧化碳汽化器汽化,開啟V3回氣閥(根據用戶回氣管路的設置,V3回氣閥可置于常開狀態)從汽化器分流出來的氣體返回儲罐上部,使儲罐內增壓。
Open the V2 drain valve to vaporize the liquid carbon dioxide vaporizer and open the V3 return valve (the V3 return valve can be normally open depending on the return air line of the user). The gas diverted from the vaporizer returns to the upper part of the tank , So that the pressure tank.
2.3.2當儲罐內壓力達到2.1Mpa時,可暫時關閉V3回氣閥。
When the tank pressure reaches 2.1Mpa, the valve can be temporarily closed V3 return gas valve.
2.3.3排液過程中,可通過控制V3回氣閥的開度,使增壓能力維持在壓力穩定的水平。
During drainage, the degree of pressurization can be maintained at a pressure-stable level by controlling the opening of the V3 return valve.
【產品詳情圖片】
-/gjehec/-

http://www.7qe.net
產品推薦

Development, design, production and sales in one of the manufacturing enterprises

您是第9595633位訪客

版權所有 ©2025-05-12 魯ICP備11026805號-109 山東中杰特種裝備股份有限公司 保留所有權利.

技術支持: 八方資源網 免責聲明 管理員入口 網站地圖
百度首頁推廣咨詢電話:18938958134 蔡經理 微信同號
吉隆县| 同仁县| 常山县| 平果县| 夏邑县| 陇西县| 海安县| 吴忠市| 基隆市| 扎兰屯市| 沾化县| 都江堰市| 叶城县| 安龙县| 博客| 曲周县| 贡山| 蒙山县| 慈利县| 凤台县| 宁河县| 楚雄市| 洪湖市| 新民市| 双柏县| 奉贤区| 凤庆县| 河东区| 奉新县| 芦山县| 阿拉善右旗| 乌兰浩特市| 泸水县| 德清县| 固始县| 桂平市| 清水县| 天祝| 成武县| 都江堰市| 育儿|