品牌中杰特裝
型號CFL-20/2.16
類型低溫儲罐
材質16MnDR
適用物料LCO2
液體的儲存 liquid storage
液體二氧化碳的儲存屬于帶壓(壓力不低于0.8Mpa)儲存。儲存期間除壓力表、液位計、安全閥應投入使用外,其他閥門應處于關閉狀態。當儲罐壓力超過2.1Mpa時,開啟V7排氣閥降壓。但應注意:內罐的壓力不得降至低于0.8Mpa,否則將引起液體二氧化碳轉變?yōu)楦杀?br>Liquid carbon dioxide storage with pressure (pressure not less than 0.8Mpa) storage. During the storage, the pressure gauge,level gauge, safety valve should be put into use, the other valves should be closed. When the tank pressure exceeds 2.1Mpa, open the V7 exhaust valve buck. However, it should be noted that the pressure inside the tank must not drop below 0.8Mpa, otherwise liquid carbon dioxide will be converted to dry ice.
【產品詳情圖片】
【標題】

【標題】
【變量2】【變量1】
【產品詳情圖片】
山東中杰特種裝備股份有限公司是國內知名的低溫儲罐生產廠家,具有A1,A2壓力容器設計、制造許可證,專業從事液氧LO2、液氮LN2、液氬LAr、液態LCO2及液化天燃?xì)猓↙NG)等低溫液體貯罐、大型常壓貯罐和Ⅰ、Ⅱ、Ⅲ類非標壓力容器設備、化工設備,產品廣泛用于制藥、石油化工、有機合成、冶金、食品、醫療、生物工程、國防等行業。三十幾年來,企業規模不斷發展壯大,現擁有固定資產3.5億元,生產廠區3個,具有先進的加工設備和完善的檢測設備,公司現有職工800余人,年銷售4億多元,并把低溫壓力儲罐作為公司爆品打造。
【產品詳情圖片】

1、操作前的準備 Preparation before operation
【產品詳情圖片】
1.1 操作者應按本說明書要求及有關文件進行操作。The operator shall follow the instructions and related documents to operate.
1.2正式投入使用前,用干燥的CO2氣體對整個系統進行吹除置換,吹除置換所用的氣體純度不低于充裝介質的純度。Formally put into use before the use of dry CO2 gas blowing the entire system replacement, purge replacement gas purity of not less than the purity of the filling
【產品詳情圖片】
【主變量】【變量3】【變量2】【變量1】

儲罐的增壓 Tank pressurization
【產品詳情圖片】
當儲罐向外供液又需要穩定排液壓力時,可利用汽化器(另外配備)進行增壓。其操作過程如下:
The carburetor (available separately) can be used for boosting when the reservoir is supplied externally and requires stable discharge pressure. The operation is as follows:
2.3.1開啟V2排液閥,使液體二氧化碳汽化器汽化,開啟V3回氣閥(根據用戶回氣管路的設置,V3回氣閥可置于常開狀態)從汽化器分流出來的氣體返回儲罐上部,使儲罐內增壓。
Open the V2 drain valve to vaporize the liquid carbon dioxide vaporizer and open the V3 return valve (the V3 return valve can be normally open depending on the return air line of the user). The gas diverted from the vaporizer returns to the upper part of the tank , So that the pressure tank.
2.3.2當儲罐內壓力達到2.1Mpa時,可暫時關閉V3回氣閥。
When the tank pressure reaches 2.1Mpa, the valve can be temporarily closed V3 return gas valve.
2.3.3排液過程中,可通過控制V3回氣閥的開度,使增壓能力維持在壓力穩定的水平。
During drainage, the degree of pressurization can be maintained at a pressure-stable level by controlling the opening of the V3 return valve.
【產品詳情圖片】
-/gjehec/-
http://www.7qe.net